+

Please confirm you are not a robot

Tub & Wall Peel & Stick Caulk - Wide

Write Review
Write Your Own Review
You're reviewing:Tub & Wall Peel & Stick Caulk - Wide
Rating
Write Review
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

Recaulking your tub and wall doesn't have to be a pain with Magic Tub & Wall Peel & Stick Caulk. It's designed to provide a flush seal without the usual mess of caulking. Width: Wide

$7.25
-
+

Additional Supplies Needed: Caulk removal tool, paint thinner or mineral spirits, scouring powder, scrubbing pad, rubbing (isopropyl) alcohol, paper towel or clean rags, tape measure, scissors

Directions: For proper adhesion, please follow the instructions carefully. Utilize proper protective equipment when completing this project. Review all cautionary information on each manufacturer label for guidance.

Surface Preparation:

Preparing the surface is critical to successful adhesion of Magic Peel & Stick Caulk.

  1. Remove all existing caulk. Paint thinner or mineral spirits can be used to soften caulk prior to removal.
  2. Thoroughly clean the surface with scouring powder to remove all residue, and then rinse with water.
  3. Wipe previously caulked areas with rubbing alcohol.
  4. Dry all surfaces thoroughly.

Caulk Strip Preparation:

  1. Measure each side of the tub where you would like to apply the caulk and cut strips of caulk to length. For a standard tub surround, use three separate strips of caulk. Do not continue the same length of caulk around corners.
  2. Pre-bend each strip of caulk by folding it at the score line that runs down the middle to form a 90° angle.
  3. In corners where two strips will meet, cut the bottom half of the strip at a 45° angle to create a flat mitered corner.

Application:

  1. Start with the longest strip. Without removing caulk backing, place one end of the pre-bent strip in corner where the wall and tub meet. Take care to keep caulk from getting wet during application.
  2. Starting in the corner, peel a small section of the backing from the top half of the strip. Press top half of strip firmly to the wall. Work carefully to avoid having to reposition the strip once adhered.
  3. Working in small sections at a time, continue to slowly pull off backing and press the strip firmly to the wall until the entire top half of the strip is adhered.
  4. Repeat process for bottom half of strip. Press bottom half of strip firmly against tub to complete installation.
  5. Repeat the process for the shorter strips of caulk.
  6. Wait a minimum of 12 hours following installation before using tub or shower.
How do I use this product around corners?

You will need to cut the caulk into separate pieces and align them at the corner

Can I use this on top of existing caulk?

No. Prepping the surface is critical to the product working correctly. Part of those prepping instructions (which you can find under the “Directions” section) includes removing all existing caulk from the area for proper adhesion.

Magic Peel & Stick Caulk is an easy alternative to traditional caulk. Designed to create a tight seal between the bathtub and wall to keep moisture out.

Size: Wide - 1 5/8" x 11' (4.1cm x 3.4m)

Color: White or Almond