+

Please confirm you are not a robot

Tub & Floor Peel & Stick Caulk

Write Review
Write Your Own Review
You're reviewing:Tub & Floor Peel & Stick Caulk
Rating
Write Review
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

Recaulking your tub and floor doesn't have to be a pain with Magic Tub & Floor Peel & Stick Caulk. It's designed to provide a flush seal without the usual mess of caulking.

$7.25
-
+

Additional Supplies Needed: Caulk removal tool, paint thinner or mineral spirits, scouring powder, scrubbing pad, rubbing (isopropyl) alcohol, paper towel or clean rags, tape measure, scissors

Directions: For proper adhesion, please follow the instructions carefully. Utilize proper protective equipment when completing this project. Review all cautionary information on each manufacturer label for guidance.

Surface Preparation: Preparing the surface is critical to successful adhesion of Magic Peel & Stick Caulk.

  1. Remove all existing caulk. Paint thinner or mineral spirits can be used to soften caulk prior to removal.
  2. Thoroughly clean the surface with scouring powder to remove all residue, and then rinse with water.
  3. Wipe previously caulked areas with rubbing alcohol. 4. Dry all surfaces thoroughly.

Caulk Strip Preparation:

  1. Measure the side of the tub where you would like to apply the caulk and cut strip of caulk to length.
  2. Pre-bend strip of caulk by folding it at the score line that runs down the middle to form a 90° angle.

Application:

  1. Without removing caulk backing, place one end of the pre-bent strip in the corner where the tub and floor meet. Take care to keep caulk from getting wet during application.
  2. Starting in the corner, peel a small section of the backing from the top half of the strip. Press top half of strip firmly to the tub. Work carefully to avoid having to reposition the strip once adhered.
  3. Working in small sections at a time, continue to slowly pull off backing and press the strip firmly to the tub until the entire top half of the strip is adhered.
  4. Repeat process for bottom half of strip. Press bottom half of strip firmly against floor to complete installation.
  5. Prevent water contact with caulk for a minimum of 12 hours after installation.
How do I use this product around corners?

You will need to cut the caulk into separate pieces and align them at the corner.

Can I use this on top of existing caulk?

No. Prepping the surface is critical to the product working correctly. Part of those prepping instructions (which you can find under the “Directions” section) includes removing all existing caulk from the area for proper adhesion.

Magic Peel & Stick Caulk is an easy alternative to traditional caulk. It is designed to create a tight seal between the bathtub and floor to keep moisture out.

Size: 1 1/4" x 5' (3.2cm x 1.5m)